Once the above steps are done you could insert the pi zero into the printer and power it on. Then 'Yes' when it asks if you want the hardware enabled.Īt this point you might want to double check that the ssh server is running:Īnswer 'Yes' when asked if you would like the SSH server to be enabled. Then 'No' when it asks if you want a login shell to be accessible over serial. Once logged in with the above credentials, you could run 'sudo raspi-config' which will start the utility and then select: Since PrusaPrint is outdated and no longer maintained, I would suggest downloading a fresh Octoprint image and write that to the sd card, instead of using PrusaPrint.The download/install instructions on the Octoprint web page are clear and will also help you setup the wifi connection.Once the Octoprint Image has been written, if you have the possibilty you could connect the hdmi output of the pi zero to a display (by powering it via USB, also additional USB keyboard would be needed) to see if it successfully boots up and run the config utility.Once booted you will be asked for a username/password, user = pi, password = raspberry

Raspberry pi zero w octoprint